AFR(Air/Fuel Ratio) Installation

[BeeH]

Hey,
Just wondering if there's any one at all that knows how to install an Air/Fuel Ratio Gauge??
btw..i have a 97' DC2 VTIR..
if there's any one that can help thanks!!

BeeH

[connorling]

i dont have the pic, but to install the sensor, u need a welder and a drill.

jet up the car, u will see a O2 sensor at the outlet of the header, u drill a hole near the O2 sensor. beware the drill doesnt drill on the O2 sensor.

then u find a nut that fit into the A/F ratio sensor, then weld that nut onto the hole, apply white tread tape on the sensor, screw it in.
the rest should be on ur gauge manual.

to sum up, drill hole near the o2 sensor, weld a nut that fit ur sensor onto the header(cover the hole), then apply tread tape on the tread, tight the sensor in.

wiring should be easy, usually black one is grounding, connect to any metal part of the car body.
find a source that have electricity when ur car is running, connect the power wire to it.
find a source that have electricity when u turn on the light, connect the DIM(i think that is wt they call it) wire to it.

mount the gauage, n u r done.

if u dont know how to weld, ask the shop to install it, it cost about $60 in perth