AFR(Air/Fuel Ratio) Gauge Installation

[BeeH]

Hey,

Just wondering, any one know how to install an Air/Fuel Ratio Gauge in.
BTW, it's a 97' DC2 VTIR if that helps.
if there's any one that knows plz help..
thanxs..

BeeH

[saxman]

just curious... do you have a wideband o2 sensor hooked up? If not, you realize that they're pretty much worthless other than making a pretty light show, right?

[BeeH]

yeah i know this man....
my main question is if there's any one that knows how to install it????

thanx ne waiz brah

BeeH

[saxman]

figured I'd ask... there are a lot of people out there that buy these thinking they are actually useful.


As for hooking it up, what question do you have? what wire to tap into? how to mount it? etc

[ProECU]

you'll need to tap into 12v,O2 Signal and Ground.

At the ECU:
A26 = GND
A25 = Ignition P2 (12v)
D14 = O2 Sensor Signal.

[BeeH]

This is were i connect the three wires right??
do i just tap these wires??

[BeeH]

the only wire im stuck in is the sensor one coz yeah i dunno know were my ECU is so i just tapped the power wire into the positive of the ciggie lighter and the ground to a screw on the car....just dunno were the last sensor wire goes too..

[michael_antoi]

find ur ecu at the near the side wall underneath the glove compartment.

look for ecu pin number D14 as per this diagram.

connect ur 3rd wire to this


http://www.hondaswap.com/forums/index.php?act=Attach&type=post&id=32

[BeeH]

aiight thanx Dudes

BeeH