jdm vtir, problem lowering

[kiss]

i decided to get some lowered springs on my car, but ran into a dilemma cause the jdm coils are different to the audm specs that the place i went to has.

i know quite a few of you guys have jdm's (92-96) and some have been lowered,
did you guys run into this problem? i didnt wanna give the guy the 'go ahead' because they could not be the right ones

and does anyone know the specifications of the coils, diameter, width, size of the coil material etc

they would have made them for me but according to their source, theres no 4ws ludes theyve ever encountered before,

OR
are they just the same as the audm 92-96 ludes

any help is appreciated guys

[destrukshn]

mate has a 94 lude with 4ws, and it is audm.

[kiss]

but isit a si or si-vtec (vtir)

[Cartoon]

just get a set from japan man n save ya salfe the hassel.
personaly i would not wanna be a co's tester unless i was getting the product for cheap as

[BigWillieStyles]

i would post this on PA mate

[kiss]

have already,
absolutely no replies

[bigteethygrin]

i've never heard of this before.. thought springs were the same. I know the mounts will be the same so the only diff I could suspect is the struts themselves.. If that is the case then just get a set of audm struts.. the spring seats should then be to the specs your after.

[kiss]

thanks phil
im just gonna get them made, if there are any problems, i'll just have to sell the springs

jdm is only good in japan lol