brake cylinder stopper install troubles

[vinnY]

http://img225.imageshack.us/img225/536/cylinderstopper5et.th.jpg (http://img225.imageshack.us/my.php?image=cylinderstopper5et.jpg)

do i keep or remove the cylindrical thing at the end to push my brake cylinder? at the moment, if i leave it on i won't be able to bolt it to my chassis to push the cylinder. if i take it off then the screw itself could make direct contact and keep the cylinder in place.

i've been assured by yonas that it is an ek brake stopper and it lines up fine with the holes.

[vinnY]

no one? :(

[EG5[KRT]]

did u move all the wiring harnesses around so that u could fit the stopper ?

also it is different with abs and non abs model stopper ??

the cylindrical thing should stay on.

[vinnY]

removed everything, its just physically impossible to fit the item in my ek :(

http://img67.imageshack.us/img67/5681/bolt10mp.th.jpg (http://img67.imageshack.us/my.php?image=bolt10mp.jpg)
http://img496.imageshack.us/img496/3756/bolt25bu.th.jpg (http://img496.imageshack.us/my.php?image=bolt25bu.jpg)
http://img496.imageshack.us/img496/1186/bolt34xo.th.jpg (http://img496.imageshack.us/my.php?image=bolt34xo.jpg)
http://img67.imageshack.us/img67/535/bolt42fc.th.jpg (http://img67.imageshack.us/my.php?image=bolt42fc.jpg)

the bottom part of the stopper touches the brake cylinder, leaves me unable to bolt it on :(

[PhatSol]

Did they send you the right part? Also, is the stopper designed for non-abs and you have abs?