Disciple
23-03-2006, 10:28 PM
hey guys i went to dyno my car today and we ran into some problems with the car cutting out and check engine lighting up. I have no idea what it is and it wasted the dyno time because in the end i ended up without a tune because it couldnt run to its full potential.
When reving it out in 4th the check engine would randomly come up which caused loss of power.
I checked the ECU check and the only problem that came up was #20 Electronic Load Sensor (ELD). Other than that there is no problem i know of.
Im running a stock ecu that is apparently chipped and we were tuning through a VAFC II, all wiring for the vafc was looked over and it was all good.
EG B16A2
MODS:
ITR gearbox LSD
CAI with trust filter
VAFC II
2.25" exhuast
Chipped std ecu
Dyno'd 92.8 ATW
Other than that its all pretty much standard.. Any ideas or suggestions?
When reving it out in 4th the check engine would randomly come up which caused loss of power.
I checked the ECU check and the only problem that came up was #20 Electronic Load Sensor (ELD). Other than that there is no problem i know of.
Im running a stock ecu that is apparently chipped and we were tuning through a VAFC II, all wiring for the vafc was looked over and it was all good.
EG B16A2
MODS:
ITR gearbox LSD
CAI with trust filter
VAFC II
2.25" exhuast
Chipped std ecu
Dyno'd 92.8 ATW
Other than that its all pretty much standard.. Any ideas or suggestions?