sleeving b16

[EGBOY]

just curious as to what sort of power a stock b16 can take without sleeving?
what sort of boost etc..

i have the opportunity to sleeve it now while its all apart, i know its probably worth doing now then i wont have any hassels with it, but i'm just curious as to what sort of pressure the stock sleeves can take..


thanks

[EGB16A]

asuming your going to put in forged pistons, with the right set up you can make 300wkw on stanrard sleeves.

Re sleeve for more power than that:thumbsup:

[jimmeh]

it cost 2500 ask toda as i might be slightly off on that price

[Slow96GSR]

If that's in AUD it's close. Here it's $1800 USD to put the Darton MID sleeves in, bore/hone, deck, clean, get a full ARP stud kit, and ship both ways. Toda will be a little more because of the name. I charge about $1400USD to do a darton 4 cylinder kit including shipping back. The MID sleeves retail is only about $700USD for a 4 cylinder. Just a rebore Darton kit is about half that or less.

$2500AUD = $1878.71USD. I don't think Toda's off.

See my 1st car page to see the MID sleeves... they're sexy!!

[jimmeh]

If that's in AUD it's close. Here it's $1800 USD to put the Darton MID sleeves in, bore/hone, deck, clean, get a full ARP stud kit, and ship both ways. Toda will be a little more because of the name. I charge about $1400USD to do a darton 4 cylinder kit including shipping back. The MID sleeves retail is only about $700USD for a 4 cylinder. Just a rebore Darton kit is about half that or less.

$2500AUD = $1878.71USD. I don't think Toda's off.

See my 1st car page to see the MID sleeves... they're sexy!!
i never said toda was off i said i might be off by a couple of dollars. i call them up about 1.5 years ago and thats what i got quoted.

[Weq]

dynodave does sleeved engines these days.

U can make plenty of power on stock sleeves. MRJDM's car was much more then a handful with only 240kw atw.

[TODA AU]

Std sleave are good for upto 300kw @ wheels.
NB: This is dependant on tuning, poor tuning will blow the engine to bits long before this.

FWIW,
We charge $2250 incl gst for TODA sleave kit. (Approx US$1690 )
4cly engines, B16A / B18C / SR20DET etc.
Includes TODA liners installed, bore & hone using head plate @ engine operating temp, deck block, clean & ship both ways.
Machining done by TODA Racing Japan.

Replacement cylinder block also available at additional cost.

[EGBOY]

TODA AUStd sleave are good for upto 300kw @ wheels.
NB: This is dependant on tuning, poor tuning will blow the engine to bits long efore this.


Would it be wise to run a block guard with figures nearing this output? or would it be fine just running a decent headgasket like a commet or something?

[saxman]

block guards are bad... there was a nice right up on here about 'em a while back...

[Slow96GSR]

Block guards are teh suk!! I had one, I know!! NEVER GET ONE!! Cheap fix for a while but when it screws you, you'll pay for it dearly in the end! Wanna hear more PM me!! Too long to type up!!