EK4R
01-08-2006, 08:15 PM
hey guys
do the ends of the oem front bumpers on the 96-98 civics have a concaved mould where it lines up with the fender? (where the screws are)
cos my fender do but my bumper dont?? and when i screw it together, it leaves a gap.
ill try get some pictures up asap to clearify
(below is an iilustration, you need to turn it 90 degrees clockwise. the top layer is my fender, and bottom is my front bumper, it has a groove and when i join both, the groove pushes my bumper outwards so leaving a gap. the arrow is the screw)
| |
| |
-)|>
| |
do the ends of the oem front bumpers on the 96-98 civics have a concaved mould where it lines up with the fender? (where the screws are)
cos my fender do but my bumper dont?? and when i screw it together, it leaves a gap.
ill try get some pictures up asap to clearify
(below is an iilustration, you need to turn it 90 degrees clockwise. the top layer is my fender, and bottom is my front bumper, it has a groove and when i join both, the groove pushes my bumper outwards so leaving a gap. the arrow is the screw)
| |
| |
-)|>
| |