d16a8 Removal

[Bayani]

Anyone got a guide as to how do to it?
Got advice it's rather straight forward, but would like some structure to removing mine.

From an CRX Si ED9

[ECU-MAN]

click this (http://www.ozhonda.com/forum/showthread.php?t=46374)





.
.

[Paul1985]

-put car on jack stands (hoist if you have one)
-remove battery
-remove front wheels and splash shield
-remove rad cap and drain coolant
-remove rad hoses and heater hoses
-drain engine oil and tranny oil
-remove the whole air intake assembly
-remove the wires from fuse box
-remove fuel lines/hoses
-remove throttle and clutch cables
-remove the engine wire connectors on both shock towers
-remove any grounds (rocker cover, tranny) and the starter motor wires
-remove the PS belt and pump
-remove the AC belt and compressor
-remove the front part of the exhaust
-remove shift linkage
-remove driveshafts (do this by removing damper fork and removing lower arm balljoint)
-remove mounts (with engine secured)

[Bayani]

I'm putting another d16a8 engine into the bay, so what from that list changes? ^_^