ISO 14230 diagnostic port

[christmas]

hey guys can anyone tell me where to find this in a 99EK, ;)
cheers
christmas:wave:

[christmas]

B_U_M_P
anyone help??
cheers

[notorious_ahmie]

http://en.wikipedia.org/wiki/On_Board_Diagnostics

check that out..whether or not it helps..i dunno ahaha :)

[yourfather]

I think it would be - Pin 7 on your Honda ECU. You'll need to find an ECU wiring diagram, and look for the K Line

[yourfather]

Found this: Might be helpful for you...



This article exploits a combination of ECU pin locations and wire colors for all M/T '96-98 Civic and '96-99 Integra VTEC and NON-VTEC vehicles.
OBD2A PLUG CONFIGURATION

Below is an example that shows the onboard (female) connector configuration for an OBD2a ECU.
Take note of plugs: A, C, and D.
The blank connector (B) is only used with civic/integra vehicles equipped with A/T.

http://www.ff-squad.com/technet/wiring/obd2a/plugs.jpg
(http://javascript%3Cb%3E%3C/b%3E:;)
http://www.ff-squad.com/technet/wiring/obd2a/obd2a.pin.schematics.gif



ADDITIONAL INFORMATION

These pin-out locations were cross-referenced with OBD2a Civic & Integra Helm's service manuals.

The information in this article applies to:

All US OBD2a (96-98) M/T civic ecu's
All US OBD2a (96-99) M/T integra ecu's
All JDM OBD2a M/T civic ecu's
All JDM OBD2a M/T Integra ecu's

[panda[cRx]]

somebody rep the boy :)

[Q_ball]

Done and done :)

[christmas]

cheers guys thats the opne i was after, mod please feel free to close

[CRXer]

Think its like a 16 pin connector with about 4-5 wires connected to it( depending whether u have ABS,auto tranny), located near the main under dash fuse box on an EK.