spetz
09-09-2006, 08:28 PM
A bit of a n00b question :o
If an engine has been rebuilt, and then I want to put forged internals in (pistons, rods) can this be done just by taking the crank cover off and swapping all from underneath or will the heads need to come off to slip everything down?
I am assuming that the issue might be that the cylinders might need to be honed so head has to come off?
Also, if the engine was rebuilt about 10,000 km ago, would it be ok to just put the new internals in + new piston rings and not change anything else?
If an engine has been rebuilt, and then I want to put forged internals in (pistons, rods) can this be done just by taking the crank cover off and swapping all from underneath or will the heads need to come off to slip everything down?
I am assuming that the issue might be that the cylinders might need to be honed so head has to come off?
Also, if the engine was rebuilt about 10,000 km ago, would it be ok to just put the new internals in + new piston rings and not change anything else?