Oxygen sensor

[fat_85_civic]

Hey
I put some extractors on my car today but when i unscrewed the oxy sensor from the stock manifold it was seized in and the threads are now stuffed. I have another oxy sensor buy it is for a different car (still a honda) that fits, is it OK to use this sensor?
It wont make it run lean or hurt any thing because it is telling the computer different things?
Thanks
lUke

[bennjamin]

is it the same amount of wires ? IT might hurt the car as the wires might be grouped / assigned differently .

[dsp26]

if its dead then say bye to your fuel econ while ecu is in closed loop (ie cruise and not WOT)

[fat_85_civic]

yeah it has teh same amout of wires (only one) and it pluged straight in.
Im not worroed about my fuel econ as im getting a newwie tomoz i just didntr want it to run lean,

ive been driving today and it goes fine .

[barefootbonzai]

it's fine, shouldn't be a problem.

[ECU-MAN]

as mentioned above. if the layout is the same it will work.

[iamhappy46]

All the single wire Honda Oxy sensors are the same, some just use different plugs to connect to the wiring loom.