Jdm b18c vtec?

[honda_b_blastn]

Ive finally found a engine,gearbox,loom,ecu package.However i was really after a front cut,due to it been left assembled,and the fact that im installing myself. Is it that hard to re-wire the engine ect? can i use my standard loom(jdm d15b vtec) and add on whats required if anything?
What is the average price for an engine package like this? Ive been quoted engine,gearbox,loom,ecu,drive shafts for $3000 plus shipping. yah or nah??

[gambate]

where u get it from?

[tanghy]

sir or type r engine?

[SIKCVC]

either way $3000 not bad, if you can stand waiting, get a front cut. theres so much shit on them you can sell... you usually finish off the end of the day with only very little being spent (ie maybe $2000, cheap mod really)

[TOYOL]

WHere did you get that from???

[honda_b_blastn]

well the importer rang me back today and the price has jumped just a tad....$3950 for engine,gearbox,loom,guage cluster,ecu and axles.However on top of that is radiator,front hubs with calipers ect plus $450 frieght plus customs taxs ect..So not sure if its a good thing now.might just hold off til i get my reply from private source in jap land. It was a b18c vtec out a jdm sir-g integra.

[Chi]

well if u aint taking it i will :P

[LatinoHatchCrap]

thatas a good price conbsidering you'll be getting the brakes and radiator. but you'll have make custom mounts to fit it.

[honda_b_blastn]

What do you think about the aus spec b18c? is it worth modifying? much diff then jdm? expert help please