eg92b16a
14-10-2006, 10:03 PM
Hi everyone,
I have been on Hondatech for a while but everyone seems to be here.
My clutch has gone, I think, and I want to know where is the best place to get a new clutch kit and flywheel. My budget is about 600 for both because I want to do drive shafts and seals at the same time.
This is the thread from my original post about the problem.
http://www.hondatech.com.au/forum/showthread.php?t=884
I have been looking here and haven't found any thread that is similar to my problem. have replaced the slave cylinder, bled new fluid. clutch will engage/disengage fine for a few times then will get a scraping noise from flywheel area, like using a scotchbrite pad on a fryingpan and the takeup point for clutch is almost on the floor. pump clutch a few times and move car a bit and everything goes back to ok. There's no problem with clamping.I drove home (5km) and almost home clutch pedal feels like it has lost pressure and hard to change gears. Now car is in garage at home and probably can't move it to get fixed.
I will check the master cylinder tomorrow for any leaks.
the intermittentness of the scraping sound leads me to believe that some of the clutch plate has broken off and is causing a problem but I don't know why the pedal loses feel .
Any answers would be appreciated.
Jason
I have been on Hondatech for a while but everyone seems to be here.
My clutch has gone, I think, and I want to know where is the best place to get a new clutch kit and flywheel. My budget is about 600 for both because I want to do drive shafts and seals at the same time.
This is the thread from my original post about the problem.
http://www.hondatech.com.au/forum/showthread.php?t=884
I have been looking here and haven't found any thread that is similar to my problem. have replaced the slave cylinder, bled new fluid. clutch will engage/disengage fine for a few times then will get a scraping noise from flywheel area, like using a scotchbrite pad on a fryingpan and the takeup point for clutch is almost on the floor. pump clutch a few times and move car a bit and everything goes back to ok. There's no problem with clamping.I drove home (5km) and almost home clutch pedal feels like it has lost pressure and hard to change gears. Now car is in garage at home and probably can't move it to get fixed.
I will check the master cylinder tomorrow for any leaks.
the intermittentness of the scraping sound leads me to believe that some of the clutch plate has broken off and is causing a problem but I don't know why the pedal loses feel .
Any answers would be appreciated.
Jason