PDA

View Full Version : skunk2 intake manifold on a 94 dc2 vtir b18c2


TBS33N
27-11-2006, 05:24 PM
just wondering if all my stock components will bolt straight onto the manifold? Eg throttle body etc and can i run my stock ecu?
TBS33N
18-02-2009, 11:47 AM
Ok, manifold has been installed and everything is good except for flat spot between 4500rpm and 5500rpm. How do i rectify this and has anyone fitted one and what have you done to get a smooth power curve?

Cheers
TECDUP
18-02-2009, 05:09 PM
lol took 2 years to install...
lil_foy
20-02-2009, 06:54 PM
Ok, manifold has been installed and everything is good except for flat spot between 4500rpm and 5500rpm. How do i rectify this and has anyone fitted one and what have you done to get a smooth power curve?

Cheers

Get a vtec controller of some type.

Go run it on the dyno with vtec kicking in as early as possible then run it again with it as late as possible. Find the spot where they join and adjust your vtec point to 100rpm before there.

Thats the only way you're going to do it without spending big bucks.
999 automotive
26-03-2009, 04:05 PM
hi mate, check this out.
http://www.ozhonda.com/forum/showthread.php?t=109410