View Full Version : EK airbag queston
i drive an EK1. single airbag
bought a dash from a EK4. dual air bag
is it possible to to install the EK4 dash into the EK1 dash, and having both airbags work, (using the wiring harness that i already have ) ???
bump - &reworded the question
JasonGilholme
12-12-2006, 07:42 AM
what ever you do don't sit in front of them when your turn the ignition on.
Don't want anything shorting out and triggering the bags.
Limbo
12-12-2006, 08:16 AM
i think you should be ok so long as you have the module for the airbag controller. I know some of the ek1s come with standard 2 airbags also, so it is not should not be dependent on the engine ecu except maybe a speed sensor?
ECU-MAN
13-12-2006, 12:38 PM
you can swap dashes, the wiring should be their already, but instead of an pasangers inflator you will have a dummy load resistor,
im not 100% sure if the SRS ECU will allow for the extra airbag but im 90% sure it will.
you will have to do some crash testing to know for sure, but this is expensive :)
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.