View Full Version : Throttle body upgrade
FRANKENcivic
17-12-2006, 12:12 PM
What would be a suitable TB upgrade on a D16Y4 , I want a direct bolt on if possible?;)
panda[cRx]
17-12-2006, 12:30 PM
skunk2 is a popular option these days, they fit fine on the d16y4 as far as i know. they have plenty of sizes avaiable depending on your engine setup
http://www.skunk2.com/Merchant2/merchant.mvc?Screen=CTGY&Category_Code=TB
FRANKENcivic
17-12-2006, 02:34 PM
;1010362']skunk2 is a popular option these days, they fit fine on the d16y4 as far as i know. they have plenty of sizes avaiable depending on your engine setup
http://www.skunk2.com/Merchant2/merchant.mvc?Screen=CTGY&Category_Code=TB
Thanks for the link but i am after a TB swap from another honda engine (ie: B series)?
Slow96GSR
17-12-2006, 04:02 PM
If the b-series will fit drop on a GSR or ITR, they are the same I do believe, but I think the b-series has a different bolt pattern and different lines. The IACV or other vales are on the manifold for the b-series and on the t.b. for the d-series. If they do work on each other and you want something more extreme try a Skunk2, Edelbrock, BBK, or whatever else you can find.
panda[cRx]
17-12-2006, 10:37 PM
i'm pretty sure the b-series should bolt in, not sure about sensors etc
my old d16a8 TB fits fine on my b16a IM (ahhh the things u find out when you are bored)
ALLMTR996
18-12-2006, 09:34 AM
;1010927']i'm pretty sure the b-series should bolt in, not sure about sensors etc
my old d16a8 TB fits fine on my b16a IM (ahhh the things u find out when you are bored)
Yes that is correct just use a later model B16A TB on the D series manifold that will take it upto 60mm and the ITR one is 62mm,Weq's D series turbo engine is fitted with the Skunk2 intake manifold and Dyno Dave fitted a modded B16A TB as its a direct replacement for the throttle cables and sensor's.
ALLMTR996
FRANKENcivic
18-12-2006, 09:46 PM
Yes that is correct just use a later model B16A TB on the D series manifold that will take it upto 60mm and the ITR one is 62mm,Weq's D series turbo engine is fitted with the Skunk2 intake manifold and Dyno Dave fitted a modded B16A TB as its a direct replacement for the throttle cables and sensor's.
ALLMTR996
Thanks fellas.... so basically I should source a TB froma newer model B16 and it should be a direct swap using my OEM manifold/sensors, etc??
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.