ek4 swaybar onto ek1 sedan.

[nugget666]

Would this make much of a diffrence for a 40$ mod? ( im happy to pay an extra 40 or whatever if i can fit say a type R one)

Would i be better of spending a little more and finding somthing diffrent?

also it dosnt come with endlinks. What can be used or where could i get some from.



I did a bit of searching and found this


I've read a number of posts regarding the tearing of EK4 subframes due to upgraded rear sway bars (even by a 2mm upgrade). Is fitting a standard EK4 rear sway on an EK1 sedan likely to be an issue considering that the EK1 did not have a rear sway bar at all?


http://www.ozhonda.com/forum/newreply.php?do=newreply&p=978376


What is the answer to that question?

[bennjamin]

a EK4 one should fit nps. The bar comes with small mounting plates which act as reinforcement.
Remember you need 4 x small nuts to hold the other side of the mounting bolts , as the EK1 dosent come with these welded in

[nugget666]

^ the one im buying says it dosnt have endlinks?.

so meaning i have to supply my own?

[ccibai]

^ yeah if it doesn't come with endlinks, u will need to find some

[nugget666]

^ yeah if it doesn't come with endlinks, u will need to find some



Can these be brought or have to be made specificly for the ek4 bar? so there for got to find some of a wrecker?

[ccibai]

^ i guess the easiest way is to find some ek4 endlinks off wreckers.

[egSi]

imo itll be a nice upgrade mate, but dont forget to get a wheel alignment after, it does matter and makes it all worth it :thumbsup:

[nugget666]

Jsut got to work out where to get endlinks from :(


also front a strut brace for 50$ :)

[egSi]

Jsut got to work out where to get endlinks from


Boss wrecking in Tingalpa or Hondarec in Goldcoast :thumbsup: