question about dc5 engine mounts

[X8TEENX]

hi,i currently having a set of innovative engine mount located in my rear,both side engine mount. the question is do i need to change the front one (maybe ESSM or expensive one innovative) to get better balance for my engine?? sometimes i feel my engine pull to front while i was lowered my gears..pls advice me..ty

and do i get more vibrate if i install front engine mounts

[psiwrath]

hi buddy
i installed a set of energy mount inserts into my cousins DC5(front and rear) and this increased the vibrations significantly however still very streetable. In comparison i have been in a car fitted with hasport mounts(street grade polyurethane bushings) and this was very rough, enough to vibrate the dash at lower RPM's.
If your car is currently fitted with three polyurethane bushed mounts adding the front mount shouldn't change the feel of your car to much but should reduce engine movement as DC5's rely on four engine mounts to stabilize the engine.
On another note maybe you could invest on an engine torque damper like this one.
http://img245.imageshack.us/my.php?image=feelstd4br6.jpg

[TODA AU]

http://img245.imageshack.us/img245/7114/feelstd4br6.jpg

These products sold by a variety of manufactuers are not dampers at all.
They are nothing more than a pretty alloy rod with a peice of teflon inside.
Fitting ones of these will cause more vibration than any engine mount kit you may buy.

[X8TEENX]

any1 try to get mixed essm front mount + innovative 3 mounts?
or any1 bought innovative front mounts??