PDA

View Full Version : what is this on the b20 block



MRJDM
19-06-2004, 05:21 PM
look immediately to the left of the oil filter. the thing with the black ring. im asking cos this is where you put the tee connector to feed the vtec oil line

i have another question. how does the eagle b20 conversion kit work cos they say you dont have to drill new dowel holes??

and why do you need a crank girdle? what does it do

http://honda.hybrids.jp/b20tech/images/back.jpg

Weq
19-06-2004, 07:33 PM
looks like an oil pressure sensor to me. i T'd into it for my hi-pressure oil line on the turbo.

ALLMTR
20-06-2004, 12:14 AM
Yes that is the oil pressure sender unit

Eagle use stepped dowels so you don't have to enlarge the dowel hole

You don't NEED a crank girdle but it supports the crank by adding a "brace" under it

DynoDave
20-06-2004, 02:16 PM
look immediately to the left of the oil filter. the thing with the black ring. im asking cos this is where you put the tee connector to feed the vtec oil line

i have another question. how does the eagle b20 conversion kit work cos they say you dont have to drill new dowel holes??

and why do you need a crank girdle? what does it do

http://honda.hybrids.jp/b20tech/images/back.jpg

The sensor directly to the left of the oil filter is the oil pressure switch,the
hole that you have circled above the oil filter is the hole for the knock sensor.and as far as girdles for the bottom end go as ALLMTR said you do not need one but it does help with strength in the bottom end and stops some of the harmonics that cause sleeve cracking.
Regards Dyno Dave