nd55
07-03-2007, 11:23 PM
Hey,
does anybody know if it's possible to fit an intermediate shaft and equal length axles into a D16Y4 EK1?
D16's as fitted to EK1's use 25spline axles.
The mount points for the intermediate shaft carrier are present on D16's.
Apparently JDM ZC DOHC D-series motors came with this configuration but I can't seem to find the relevant information, eg spline counts and if any oz honda's used these parts.
The goal is to minimize torque steer effects, hopefully economically.
Nick.
does anybody know if it's possible to fit an intermediate shaft and equal length axles into a D16Y4 EK1?
D16's as fitted to EK1's use 25spline axles.
The mount points for the intermediate shaft carrier are present on D16's.
Apparently JDM ZC DOHC D-series motors came with this configuration but I can't seem to find the relevant information, eg spline counts and if any oz honda's used these parts.
The goal is to minimize torque steer effects, hopefully economically.
Nick.