Custom grind cams

[Drew]

Is there anyone that specializes in custom camshafts in Victoria, pref. Melbourne

The H23A in the wagon has a slight knock at low rpm, only happens when you floor it from a stop, only a single knock however so something is probably a bit loose in the engine...

So I might as well do the cams while the engine is apart...
There's a few places in New Zealand that manufacture custom camshafts but I'd really rather use someone local-ish now

Speaking of the wagon, DOTARS charged my credit card on Friday, so the import approval must be right around the corner... oooooh so excited

[EG5[KRT]]

mayb the car is pinging.. u mite need to retard the ignition timing a bit or mayb use better fuel...

[Drew]

It's definitely the motor, ran it on 98 Octane and the timing is spot on

If you've heard it there would be no two ways about it being a knock from the motor

[EG5[KRT]]

big end bearing ??

[Drew]

We'll see once it's apart but for now lets worry about the cams shall we ^_^

[Slow96GSR]

If there is no one there Crwoer will do a custom cam set for you. www.crower.com . Toda or Skunk might also do them.

[Muzz]

maby PM adrian from toda, he might be able to help. he goes by toda au on here.