New Bushes

[riruiz_88]

not sure it this should be here or in noob. move it if u want.
i got these new bushes for my EG5 Si hatch. these are for the front sway bar. wat i want to know if these are the same bushes for the rear. help needed cause i want to change the rear sway bar bushes, but in the nolathane catalogue it dosnt have any bushes for the rear swaybar.
here they are >>> p.s. sorry for crappy photo, took it with my phone
http://i156.photobucket.com/albums/t18/riruiz_88/Photo-0037.jpg
http://i156.photobucket.com/albums/t18/riruiz_88/Photo-0036.jpg

[bennjamin]

Since we cant tell to scale -

can you please measure the TOP picture , the INNER diameter of the bush ?
This will give you the swaybar DIAMETER its designed for.

If its about 22-24mm , its for the FRONT swaybar.
If its 14mm , its for the REAR swaybar.

The bushes on the BOTTOM are for the FRONT swaybar endlink connections - there are a series of washers and bushes on either end of the swaybar that connects to the lower control arm.

[riruiz_88]

hey man, the top picture is 18mm in diameter. its hard to find sway bar things for an Si. cause only the Vti and Si came with rear sway bar right? so help would be good, if anyone could give me any suggestions alls good to go ahead :wave:

[bennjamin]

hey man, the top picture is 18mm in diameter. its hard to find sway bar things for an Si. cause only the Vti and Si came with rear sway bar right? so help would be good, if anyone could give me any suggestions alls good to go ahead :wave:

18mm ? Can someone please measure up a STOCK front swaybar and find out the diameter ?
BTW , yes , the only EG's with a rear swaybar were the Si + Vti (both 14mm)