DC2R 282mm Project Mu SCR Pro + spoon twin block caliper

[dynosaur]

Hi , I m plan to put in 282mm Project Mu SCR Pro + spoon twin block caliper into my JDM DC2R ( 96 Spec ).

But had some question dun understand...

will the spoon caliper fit into SSR Type C 16" , offset +42 ?

still need to add spacer or not if using this rims ?

with this set up , OEM 15" still can fit into it ?

thanks in advance....

[PaZzMaN-R]

he clearly states he is not using the stock rims!
whats the offset on the stock rims again?
they should fit but could someone confirm?

[EG5]

he clearly states he is not using the stock rims!
whats the offset on the stock rims again?
they should fit but could someone confirm?

+50:thumbsup:

[tune2look]

Dont you have the same setup on your EGK20A yonas?
I think I saw it the otherday when you were trying BC P1 on.
In my memory, the wheel was 15(P1) and it fitted fine.
Comparing the design of those two rims, I think SSR will fit.

[tune2look]

oviously offset-wise anyway.

[Samo]

15' rims will fit ... but it comes down to the offset

they fit on audm dc2r rims with spacer