PDA

View Full Version : Sound of Vtec kick in



dyljoy
12-04-2007, 03:23 AM
Hey, everyone, I installed the Toda header for my DC5R today, and taste it when it done, i and my friend feel its sound of Vtec kick in just gone, even push it to over 7000rpm, just can hear its catback noise. Is it normal? sorry for my such stupid Q's~Hope someone can give me some opinion, thx~

SloTegra
12-04-2007, 10:45 AM
i have noticed that too - my friend owns a dc5R - toda headers - toda cams - and a RM01A catback.. his v-tec doesn't seem to be loud, but i think its like that if u compare the K series and the B series maybe cause its a different block design?

bennjamin
12-04-2007, 11:28 AM
its the design of the engine ~there inst supposed to be a massive BAAAAA when vtec engages.
On the older B series motors there is a more noticeable booooooBAAAAAAA.

dyljoy
12-04-2007, 01:09 PM
oic, maybe i used to head that noise already~hoho, ok, seems i have to change my taste again

defect
12-04-2007, 11:13 PM
turbo sounds better :D

Q_ball
12-04-2007, 11:15 PM
turbo sounds better :D

Turbo + vtec = boooooBAAAAAAAAAAAAAAtutututututu

kn1ghtm4r3
12-04-2007, 11:25 PM
get a cai and make it stick outside the car should be loud then lol

Joeyboy
12-04-2007, 11:59 PM
Turbo + vtec = boooooBAAAAAAAAAAAAAAtutututututu

cai + vtec + turbo = fffffbooooooBAAAAAACCHHHSSSHHHHHH ??? lol

xV73Cx
13-04-2007, 12:02 AM
get a cai and make it stick outside the car should be loud then lol

ive got my CAI just behind the front bar and its quiter than it was short ram.. :(

reason to this i think is the tube is longer and further for the air flow to travel and echo ..but in short ram mode it was load as hell!!

thats the benefit of a 2 piece CAI ...take off the 2nd short tube and use as short ram! :p

xV73Cx
13-04-2007, 12:05 AM
cai + vtec + turbo = fffffbooooooBAAAAAACCHHHSSSHHHHHH ??? lol

cai+vtec+turbo+nos+8inch barrel zorst+PA Microfone = fffffbooobaaaaaswhhhBAAAAAAhhhuuurrrchhh-FTW!!! ROFL!!

:wave:

Bayani
13-04-2007, 12:18 AM
Wont somebody PLEASE think of the children!!?!

TheSaint
13-04-2007, 12:39 AM
or at least the small n/a pandas.....

cute little things

Joeyboy
13-04-2007, 12:42 AM
dont u ppl go to sleep?! *ahem*

chunky
13-04-2007, 01:00 AM
this thread is getting spammed up

aaronng
13-04-2007, 02:03 AM
The reason you don't hear the vtec crossover point in a K series when you installed your headers is because the sound of the exhaust flow is much louder than the sound of your induction roar using the stock airbox. Just put on a louder intake and you'll hear it again.

dyljoy
13-04-2007, 08:56 AM
oic, thanks for ur answer, i think u are right, coz i am using Mugen airbox atm, and it is very similar as stock box's design, may exahaust sound louder than the induction roar's voice.

TheSaint
13-04-2007, 10:17 AM
dont u hear the vtec kik in through the exhaust as well?

what about B series? (B18c)
im just about to go from short ram to CAI, and ill be getting a toda header + mugen twin -loop combo.... will i loose engine noise?

DreadAngel
13-04-2007, 10:28 AM
Turbo + vtec = boooooBAAAAAAAAAAAAAAtutututututu

Get a VTEC conversion on your engine then loser :thumbsup: :p

kn1ghtm4r3
14-04-2007, 11:42 AM
ive got my CAI just behind the front bar and its quiter than it was short ram.. :(

reason to this i think is the tube is longer and further for the air flow to travel and echo ..but in short ram mode it was load as hell!!

thats the benefit of a 2 piece CAI ...take off the 2nd short tube and use as short ram! :p

mines louder then wen i had my diy sri lol heaps throatier =) sounds mad lol and on cold days its even more insane lol :thumbsup:

schuebyTeG
04-09-2008, 10:18 PM
On the older B series motors there is a more noticeable booooooBAAAAAAA. - bennjamin

IS say a 93 engine gonna sound differnt to a 97 ?
They the same ?

93 will be louder ( better ) cos its older ?


thx

redinteg
05-09-2008, 11:41 AM
please start an UBERNOOB forum

02gzm
05-09-2008, 11:50 AM
The reason you don't hear the vtec crossover point in a K series when you installed your headers is because the sound of the exhaust flow is much louder than the sound of your induction roar using the stock airbox. Just put on a louder intake and you'll hear it again.
x2
My mate has a full toda exhaust system and a gruppeM intake on his jdm dc5r. I nearly wet myself the first time i heard it hit vtec while in the passenger seat :P

Q_ball
05-09-2008, 11:53 AM
Ffs, this is an old thread tooo >.<


- bennjamin

IS say a 93 engine gonna sound differnt to a 97 ?
They the same ?

93 will be louder ( better ) cos its older ?


thx

Ben is comparing the sound difference between the B and the K in his prior post.
B's all sound "similar" - age of a specific engine doesnt mean VTEC will be louder or quieter than the same motor give or take a few thousand kms.

NightKids
05-09-2008, 12:17 PM
VTEC is all in the mind. Think of the cat being strangled & you will have VTEC

TheSaint
05-09-2008, 09:34 PM
all cars should have vtec... i miss it so much now =(

its just not the same anymore

migoreng
05-09-2008, 09:43 PM
h22a vtec ftw! love the crossover sound ;)
pff 1.8L engines..
:P

g_kn
05-09-2008, 10:51 PM
Want loud vtec ?
B16A FTW + SRI Intake +Stock Exhaust + Windows Down:p..... Merrrrp!!!

The crossover for B16A is f@&#37;n clear & noticeable

TheSaint
06-09-2008, 02:55 AM
i found that a proper CAI was better than SRI for sound in my teg

it was deep like wrx than it screamed its head off =)

RtN
06-09-2008, 05:01 PM
yeh my 16A2 is pretty clear crossover.. lol umm h22a my friends one is completely stock can't hear much.. maybe needs intake but yeh.. my CAI sounds cute.!!

g_kn
06-09-2008, 06:33 PM
yeh my 16A2 is pretty clear crossover.. lol umm h22a my friends one is completely stock can't hear much.. maybe needs intake but yeh.. my CAI sounds cute.!!

There ya go .. B16A for loud Crossover noise :thumbsup:

TheSaint
06-09-2008, 07:31 PM
from what i have found from driving allot of different model hondas...

b18c7 (teg R) > b18c5 (teg vtir) > b16a (EM1, del sol) > K20 (dc5) > modded h22 > modded k24 > h22 > d vtec > stock k24 > i-vtec and e-vtec (the fuel saving vtec, not racing vtec)

from most distinct difference for vtec crossover noise

the K motors are deffinatly screamier but have a smoother crossover, but the B motors have a more punch in vtec

the b16 is pretty screamy but lacks low end

the h22 i drove i could hardly notice it at all, and it was a very docile motor, but it had alot more torque and of course was bigger

i-vtec and e-vtec are designed for fuel saving so they not really noisy at all, and unless u got a turbo on a D series motor they are more designed at getting u to work/church and not for racing lol

bennjamin
06-09-2008, 09:01 PM
FYI a vtir DC2 has a b18c2 engine.
The b18c5 is the USDM variant of the Integra type R engine.

TheSaint
07-09-2008, 12:26 AM
ah lol... thanks bennjamin

its been a while since iv poked my head around in these forums... iv started taking up interest again... missed the vtec way way too much haha

Elwood
07-09-2008, 04:09 PM
Maybe your engine is about to blow up.

VTECMACHINE
09-09-2008, 01:30 AM
Maybe your engine is about to blow up.

I second that.