b16a2

[WNARUN]

i was just wondering if like the b18c pistons and conrods and stuff fit into a b16a without boring the motor?

[Twincam16]

If im not mistaken you wanted to boost your motor in the past...
Link (http://www.ozhonda.com/forum/showthread.php?t=64751&highlight=b16+b18+rods)

If this is still the case, best bet is to leave internals stock and go for a T25/28/TD04 bolt on kit. AVO has a track proven setup which you can find second hand now (inc ECU) for $2-3k (130-160kwaw possible on 7-9psi).

My mate has one on his stock B16A2 (Crx) and the car has more than enough power (piggyback tuned with 135kwaw) but mid-high torque is way better than stock (not to mention fkn very responsive). Feels like car pulls like a train compared to my NA and still enough to light tyres in dry.

You dont need more than that to start with, work from there. The B16a2 has an awesome R/S ratio and changing this for an extra .2L wouldnt give as much power as a low end turbo setup, which would cost the same amount.

Save your bucks & turbo it, you wont regret it. (Unless you lose your license like I did - :) )

Good luck with it!

[WNARUN]

oh yeah thanks for that i was just wondering...

[WNARUN]

just wanted to know a few things before i got started on putting things on...
unsure still thats why