which injectors is your turbo running...

[rnbguy]

i didnt want to place this question in an american forum as they have different cars to take injectors from so thought id ask here...

I have a D16Y4 and looking at what injectors people are running, i know the usuall DSM or RC 440+ options

but anyone running something different? and which car did you pull it from? what kind of modifications needed to be done to fit them (if any)

[czy_sol87]

shouldnt this be in the forced induction section...

[rnbguy]

damn, mods move plz (shoot me later)

[STOCK]

rc440s will fit straight in

[rnbguy]

yeah not looking at spending that much on injectors... looking for alternative options as mensioned above, thanx.

[SLOWEGG]

Look for GSR/EVO lancer injectors. Heard nissan rb will fit aswell.

[imashy14u]

Yeah, i'll like to know as well.

Do GSR/EVO ones fit straight in without any additonal hardware (eg resistor box). I thought these were peak and hold (low impedance) injectors, while a D16Y4 uses saturated (high impedance) injectors.

[SLOWEGG]

Also, some people have used RX7 S4/5 550cc injectors. But some do say not to use them because of their spray pattern and others dont have a problem.

Surely you could pick up a second hand set of RC pretty cheap.

[STOCK]

the evo injectors will need resistor boxes as will the gtr injectors

[creativepunka]

I used the DSM's on my d16.

[imashy14u]

I used the DSM's on my d16.
Where did you getit from and how much? Also, did you have to modify anything to get it working?

Thanks.

[rnbguy]

ull need a resistor box, and modify the o-rings by the looks of it, they can usually be found in american ebay...

[creativepunka]

i got them from a mate in the states. i just got resistors from jaycar and wired them in.

[rnbguy]

nice and cheap, do you have a wiring diagram for how u wired it? or could you draw a silly quick one in mspaint :P

just with resister rating and wires they sit on, just as a good reference

[rnbguy]

ill use this guide to tell the difference bettween a or b:

http://www.team-integra.net/sections/articles/showArticle.asp?ArticleID=691

[Limo]

im using GTR injectors in the b16a. just needed to extend the rails to suit. not too hard to do tho.

you can use rb20/26, but not the rb25.. also c18's work..

evo/gsr also work.

[imashy14u]

im using GTR injectors in the b16a. just needed to extend the rails to suit. not too hard to do tho.

you can use rb20/26, but not the rb25.. also c18's work..

evo/gsr also work.
What do you mean extend the rails? Are the injectors too tall? Did you just spacers/washers where it scres onto the manifold? Did you have to get a resistor box for the GTR injectors? are they high or low impedance?

Thanks.