Alpine
15-05-2007, 08:50 PM
http://www.thecarkitcompany.com.au/Content...ith-display.seo (http://www.thecarkitcompany.com.au/Content_Common/pr-breese-reverse-camera-and-parking-sensors_breese-4-channel-sensor-with-display.seo)
The above shop has responded to how they intend to fit reverse sensors to my gen 1 CR-V. Because of the design of the rear bumper, they are proposing fitting three sensors as displayed in the picture:
http://img295.imageshack.us/img295/4549/crv011smallzs2.jpg
Two sensors on the far left and right corners of the bumper, with one sensor directly above the number plate housing which is offset to the left.
I am wondering if the gap left between the second and third sensors on either side of the spare wheel will present a problem with reliable scanning of the entire rear-end?
Anyone?
The above shop has responded to how they intend to fit reverse sensors to my gen 1 CR-V. Because of the design of the rear bumper, they are proposing fitting three sensors as displayed in the picture:
http://img295.imageshack.us/img295/4549/crv011smallzs2.jpg
Two sensors on the far left and right corners of the bumper, with one sensor directly above the number plate housing which is offset to the left.
I am wondering if the gap left between the second and third sensors on either side of the spare wheel will present a problem with reliable scanning of the entire rear-end?
Anyone?