Sexc86
02-06-2007, 08:17 AM
Hey guys
still possibly working out a deal to purchase this short block from the usa. Was wondering if anyone has herd of an engine builder in the usa called ERL-Performance. Located in Indiana - webpage - http://www.erlperformance.com
I have herd from a few people here both in the usa in and australia that this workshop has quite a good reputation for building honda engines. however i just wanted a more public open opinion on them? if anyone personally here has delt with them etc
For sale is a Complete ERL Built D16z6 Sleeved Short Block
Darton MID Sleeves 75.5mm (with a closed deck)
CP Pistons 9:1CR 75.5
Crower Steel Billet Rods I Beam
Micropolished Crank
ACL bearings on Rods Calico Coated
ACL Thrust Washers
ACL Race Main Bearings Calico Coated
ENDYN OEM Honda Z6 Modded Oil Pump for High Pressure. hits up to 85+psi max with oil at 180 degrees
OEM Honda Water Pump
OEM Honda Seals
Thanks in advance guys
Regards Lyle
still possibly working out a deal to purchase this short block from the usa. Was wondering if anyone has herd of an engine builder in the usa called ERL-Performance. Located in Indiana - webpage - http://www.erlperformance.com
I have herd from a few people here both in the usa in and australia that this workshop has quite a good reputation for building honda engines. however i just wanted a more public open opinion on them? if anyone personally here has delt with them etc
For sale is a Complete ERL Built D16z6 Sleeved Short Block
Darton MID Sleeves 75.5mm (with a closed deck)
CP Pistons 9:1CR 75.5
Crower Steel Billet Rods I Beam
Micropolished Crank
ACL bearings on Rods Calico Coated
ACL Thrust Washers
ACL Race Main Bearings Calico Coated
ENDYN OEM Honda Z6 Modded Oil Pump for High Pressure. hits up to 85+psi max with oil at 180 degrees
OEM Honda Water Pump
OEM Honda Seals
Thanks in advance guys
Regards Lyle