Oil Line Kit (T3)

[tekung89]

i got a T3 turbo off a RB motor, and i've searchd high and low for bolts that screw onto the turbo for the oil/water lines to be fitted on , but it seems like no one has got them. so i went back to ebay and found a oil line kit for T3's for 150ish.
can anyone tell me if this kit will include that T-peice that'll screw on and replace my stock oil pressure sensor ?

http://cgi.ebay.com.au/Turbo-Oil-Line-Kit-T3-T3-T4-T70-T04E-T04B-Garret-TURBO_W0QQitemZ140145020589QQihZ004QQcategoryZ4380 8QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

[Drew]

The T pieces you should be able to find at most plumbing outlets or Reece gas

But yes looks like it has one in there but whether it's the right thread or not is a different story

[DLO01]

Go to Pirtek with your turbo.

You will never go wrong. :thumbsup:

[tekung89]

awesome DLO01 ur a legend

[FastFwd]

i got a T3 turbo off a RB motor, and i've searchd high and low for bolts that screw onto the turbo for the oil/water lines to be fitted on , but it seems like no one has got them. so i went back to ebay and found a oil line kit for T3's for 150ish.
can anyone tell me if this kit will include that T-peice that'll screw on and replace my stock oil pressure sensor ?

http://cgi.ebay.com.au/Turbo-Oil-Line-Kit-T3-T3-T4-T70-T04E-T04B-Garret-TURBO_W0QQitemZ140145020589QQihZ004QQcategoryZ4380 8QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Tekung89 u can also go to ENZED. When i installed my GT28rs on my S15 i needed custom oil and water lines and i went to these guys and they pretty much knew exactly what ends and everything i needed. they must of done it a few times for cars. anyways here a site below if u wanna check it out

http://www.enzed.com.au/

end up costing me round $30- $45 each for a fully braided quality line

[string]

Oil return is standard flanged return that pretty much all garretts run, can't remember the feed, i'll have a look atmine in the morning. Water threads are M18 x 1.5 compared to the newer 14mm - good luck finding them though. As mentioned above, try ENZED. They'll have what you need, but you'll pay for it.

[FastFwd]

Oil return is standard flanged return that pretty much all garretts run, can't remember the feed, i'll have a look atmine in the morning. Water threads are M18 x 1.5 compared to the newer 14mm - good luck finding them though. As mentioned above, try ENZED. They'll have what you need, but you'll pay for it.


agreed - they are quite costly...but cant beet there service + Quality. i went to the lunch bar across the road and came back and they had finished all 4 lines.