Quick Ques. about Oil Sandwich Plate/Adaptors

[arron]

Hey guys,

I just got an oil sandwich plate for my press and temp gauges.

This sandwich plate is just an adaptor for the sensors only, (ie. no lines for an oil cooler). On this plate, there are 3 holes.. One for the temp sensor, one for the press sensor.. and third one.. What goes into the third thread?

Also, can anyone lead me to a wiring diagram/map for the DC2R so that I can install the gauges? I require IGN, Battery, Illumination and Ground terminals?

Thanks in advance!

[DLO01]

You can use the blank sensor holes for anything you want. Oil temp, press, you could use the 3rd one for Turbo oil feed. If you don't need it, blank it off.

As for wire colours etc. I just tested each wire with a multimeter to determine what they were for. :thumbsup:

[arron]

Thanks!

That's all I needed to know.. Will be whipping out my test light for this one..