PDA

View Full Version : ITR clutch in B16a


DA9B18C
10-10-2007, 09:05 PM
will a 96 aus itr clutch fit in a b16a cable gearbox?
kyle
10-10-2007, 09:37 PM
there is no 96 dc2r
Limbo
10-10-2007, 09:58 PM
there are some Jap spec 96 ITRs around, they were some early imports i'm seen a few around.

easiest way to find out is to find out the model number of the b16a clutch for a cable box. If its the same as the b16a hydrolic clutch its the same.

Note that the pressure plate is a different model number but i've been told it should still fit.
jdmTYPE R
10-10-2007, 10:44 PM
clutch plate will not fit as the input shaft is a different size but the pressure plate will fit
ECU-MAN
11-10-2007, 08:58 AM
as above

No
fatboyz39
11-10-2007, 10:05 AM
As above...NO...

But pressure plate will work, but there is no point
TODA AU
11-10-2007, 10:56 AM
will a 96 aus itr clutch fit in a b16a cable gearbox?

Flywheels & clutch covers are interchangable.
The Cable gearbox uses 220 X 25 X 24 clutch disc.
220mm OD, 25mm OD of splines, 24 splines (number of teeth)
The hydrulic gearbox uses 220 X 26 X 24 clutch disc.

If you use the hydrulic cover in the cable box, you will likley encounter problems with cable stretch & possible pedal box failure.
It can be welded & braced to last & a better cable can be produced.
Though you would need a considerable amount of power to warrant doing this.
Kiz_EG6
11-10-2007, 10:58 AM
Even if it would, i wouldn't bother man.
I am guessing you are talking bout a used clutch?

For the effort involved i would just go for something like an exedy or x-treme organic H.D, this will not break the bank and will be better than any o.e clutch would be anyway!!