demensions

[what the?]

are the external dementions of a B16-a or b the same as a B18-c...ie,
outer g-box case to crank pulley & throtell body to exaust.

also who's got the cheapest 1/2 cut's of either of these motors on the easern or southern state's.

[tinkerbell]

you need spelling lessons and one of these:

http://upload.wikimedia.org/wikipedia/commons/thumb/6/6e/Plastic_tape_measure.jpg/350px-Plastic_tape_measure.jpg

[tinkerbell]

(ps - the B16A block is 7mm shorter than B18x)

[what the?]

is the B16A-B the same demensions as a B18C

[smomo]

the b18c is around 0.9cm taller than the b16a due to the taller deck height, other than that everything else should be the same. I believe b16b is the same height as b18c, hopefully someone can confirm.

edit: --oops, this has already been replied to in other thread

[what the?]

I wasn't interested in a Tertiary lesson, and the tape meassure I got is a little more advanced then yours.
I'm in Darwin and there's no comparison motors to check against, in fact there not that common anywere in AU.






*bennjamin edit no need

[what the?]

thanks mate,
i can fly your web page to well its alot more advanced then the other motoring clubs in conected to,
i'm hopeing to get a absulute answer as in putting it into my moke.

theres a b16a mini in Melb the first regestered in AU done last month.
looks factory.

the last bloke to reply was a smart arse.
if you want to see some pics go to ausmini.com them to eng-upgrades and you'll see the thread to the 1st vtec mini in australia.

cheers carl

[revNhevN]

but he is right. 7mm shorter.

[Benson]

Halfcut's prices are all average:

b16a $3.5k
b18c $4-4.5k
b18c type R $6-$7k
K20a $8k-$10k

[yfin]

merged threads - pls don't start a new thread asking exactly the same question