eg

[baeshin]

i put in lca in my eg to fit in coilovers n i had to remove the swaybar ( stock swaybars that come wif si ) cus i found it hard to put the swaybar bak in after putting it in the lca. im asuming its not possible to use that sway bar n i need a dc2r swaybar cus i hav dc2r lca ?

[bennjamin]

Should fit fine. Just take your time and dont ruin the thread of the bolts or the LCA.
No , you can reuse your stock swaybar. FYI the EG Si swaybar is the same basic dimensions as a DC2R swaybar , just the EG is 14mm and the DC2R is 22 or 23mm.

[Sydsyd]

i dunno ben, i found that I had to get a DC2 swaybar when i changed my sussy to DC2R sussy cos the stock EG VTi rear swaybar that i have didn't fit the DC2R rear LCAs...

is that the case with everyone else?

[baeshin]

yeah found it hard to fit so i just didn put the sway bar back on

[T-onedc2]

As EG and DC share the same rear subframe it should fit fine, I ran my stock 14mm rear sway for a short time with my ITR LCA's. Have you got a pic?

[Sydsyd]

if i remember right, 1 end of my stock EG rear swaybar was about 1cm short (maybe less) from the rear LCA mounting point...after i got DC2 rear swaybar, it fit straight away...