PDA

View Full Version : Fender Removal



mattc
28-12-2007, 11:21 AM
hey guys

just was wondering if any of you have removed your front passenger side fender specifically the dc2?

1.do you guys know where all the bolts are etc?
2.would it be easy to replace? i.e would a new fender directly bolt straight on?
3. would an ITR fender bold directly on to a 93 dc2? same body shape etc?

Cheers and thanks for your help :)

G-Stick
28-12-2007, 11:47 AM
yea its easy to replace, the bolts are 10mms. few bolts at the top, 2 bolts in front of the doors wen doors open . and i think one at the front of the fender. yes the itr ones are the same

Samm928
28-12-2007, 11:48 AM
hey

open up your bonnet and theres 3 bolts located which are connected to the fender.. remove these bolts.. then as you open the passenger/driver side door whichever fender your taking off there should be one on the top of the door thats the height and next to the fender and there should be one at the bottom of the fender closest to the door. they are hiding behind the door. so yeh. =) umm also just a few screws under the fender. and also remember to remove the side indicator light.. take out the fender first then remove the light to avoid ripping it apart.


have fun..
new fender bolts straight on as long as its same model.. not so sure about the dc2r and the dc2 fender.. but i am supposing they are the same



regards



samm

ng-r
29-12-2007, 10:36 AM
see with the bolts under the fender
was wondering if i need to take out the sideskirt to
reach the 2 bolts?

dudeling7
29-12-2007, 11:02 AM
yeh i think you need to remove the side skirt which is cover the two lower bolts of the fender

theres a bolt or two where u open the door and finally a few that run along the top in the engine bay.

jimidy
01-01-2008, 11:23 AM
defently need to remove the sideskirt to get to the two bolts at bottom of fender then there is the ones im engine bay and one between the door

94dc2tegz
11-06-2008, 12:56 AM
just a quicky

does the front bar have to b removed for this to happen?

G-Stick
11-06-2008, 01:05 AM
yes and no really. it will be a lot easier if its off as the front bar clips on the fenders. it can prob be done. i would just take the front bar off, takes 1 min if the front bar is stock

94dc2tegz
11-06-2008, 01:18 AM
cheers