View Full Version : Oil distribution block
fat_85_civic
09-01-2008, 08:58 PM
Hey
Im slowly getting all the bits together to turbo my car and found this.
http://www.sr20forum.com/custom-steel/122300-cs-new-well-sort-turbo-na-oil-distribution-blocks.html
Does this seem like a good thing to buy?
It will make it nice an easy to get the oil feed for my turbo.
SLOWEGG
09-01-2008, 09:27 PM
You can buy a T piece that goes at the back of the block where the knock sensor/oil pressure sensor is. Not sure what sensor it is.
fat_85_civic
09-01-2008, 09:30 PM
its the oil pressure sensor. but with all the virbation of the engine a tee piece can snap off. This runs a hose from that port to the block, to stop the possibility of it snapping and also gives you a place to mount sensors for other guages.
SLOWEGG
09-01-2008, 10:51 PM
You'll be fine, many people have done it. Or you can go the sandwich plate way from the oil filter.
tekung89
09-01-2008, 11:15 PM
2nd that , i reckon jus use a Tpeice =)
oil dizzy blocks are a good idea. There is nothing bad about them. Sure u can get away without one, but for a nice, neat, easy to install/uninstall setup, i think they are great.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.