tekung89
19-02-2008, 05:55 PM
well i've wired it all correctly according to the manual book and it turns on fine. there are voltage readings of pressure, air/fuel correction and throttle and i have resetted the apexi so everything is back to default settings.
the only thing i have done is:
selected my cylinder which is 4
selected my throttle arrow to point upwards
selected 6 in 6 out for sensors
setted HI -> LOW 5000 and LOW -> HI 4900
i start the car and then it idles for abit and turns off, wat could be the problem
the only thing i have done is:
selected my cylinder which is 4
selected my throttle arrow to point upwards
selected 6 in 6 out for sensors
setted HI -> LOW 5000 and LOW -> HI 4900
i start the car and then it idles for abit and turns off, wat could be the problem