2 wire iacv to 3 wire iacv

[VTec1987]

Has anyone come across this?
Im running p06 ecu with the d16y4 motor in my eg. I used all the wiring from the d15 motor. The d16y4 motor has 3 wire iacv and the old motor has 2 wire iacv.

Does anyone know how to bypass this so the motor can run properly, it idles lyk no tomorrow but no engine light goes on. I connected two wires together and left the orange wire hanging.

[nigs]

I just adjusted my idle(screw) till it was remotely close to something acceptable.

Although a better solution would to actually fix it....hrmmmm.

[[ricer]]

buy my intake manifold and throttle body

trust me

i ran it with my po6 before

[ECU-MAN]

you need to convert to a 2 wire IACV, P06 will not run a 3 wire IACV

[[ricer]]

you need to convert to a 2 wire IACV, P06 will not run a 3 wire IACV

and theres no way on a y4 manifold and throttle body
u need a y1 or y8 intake manifold and throttle body