VTec1987
29-02-2008, 06:39 PM
Is there anything else to consider besides bridging vtec pressure switch to vtec switch to get everything running probably.
When i was using my stock obdIIa ecu, everything works perfectly with no codes throwing at me. When i used the convserion harness and p28 ecu chipped for my motor, the engine light comes on Code 1 which is o2 sensor. First i thought it was the ecu, so i changed the obd1 ecu and still the same problem.
I also changed the 02 sensor as well, still the same problem. The only thing i can think off is the conversion harness being faulty. I even check the pin out from the conversion harness going in the p28 ecu and its correct.
Anyone has this problem before?
When i was using my stock obdIIa ecu, everything works perfectly with no codes throwing at me. When i used the convserion harness and p28 ecu chipped for my motor, the engine light comes on Code 1 which is o2 sensor. First i thought it was the ecu, so i changed the obd1 ecu and still the same problem.
I also changed the 02 sensor as well, still the same problem. The only thing i can think off is the conversion harness being faulty. I even check the pin out from the conversion harness going in the p28 ecu and its correct.
Anyone has this problem before?