Pioneer Vehicle Dynamics Wiring

[nomcice]

Hey all,

I have just started wiring my Pioneer Vehicle Dynamics Unit (AVG-VDP1)
And i have a few questions:

- Where is the speedo signal on an Integra DC2?

- With the wires that go to the negative posts on the front speakers, is it ok to wire these into the negative terminal of my power amplifier? What are these wires used for?

- How can i wire in an accesory wire of the ignition? I was thinking of justwiring it of the streo loom but decided to hard wire a new one...


Thanks for your help :)

[CRXer]

Speedo signal for DC2 is either behind the gauge cluster or at the ECU connectors,its an orange wire.

For accessories connection,u will see 5 spare terminals on the front of your underdash fuse box.One of these is an accessories connection(i think the one on the far right).Just test them with meters or test light,which ever one comes on when u turn the key to accessories is the one u want.U will need a spare female spade connector to connect to it(jaycar).Dont forget to put an appropriate fuse just after this connection.

[nomcice]

ok thanks heaps for the help buddy :)

[nomcice]

anyone know about the speaker wiring?

thanks

[nomcice]

looked on theback of the speedo and can only see a green/orange wire.... is this it?

[CRXer]

Have a look at the pic below,Im assuming u got a DC2 as per your car spec.

http://i58.photobucket.com/albums/g268/CRXer/IMG_1381_1_12.jpg

[nomcice]

thanks heaps for that buddy