vinnY
11-03-2008, 09:19 AM
so i got a set of jdm 4-1 headers however it appears the little bit of piping that usually protrudes from the flange to hold the donut gasket in place has been cut off in favor of a flexi-joint attachment
now i have two questions
1. is it okay to just bolt it together with the gasket in place and hope it holds
2. can i just take the headers to an exhaust shop to weld on a little bit of piping so that i can sit the donut on as it would have been in stock form
now i have two questions
1. is it okay to just bolt it together with the gasket in place and hope it holds
2. can i just take the headers to an exhaust shop to weld on a little bit of piping so that i can sit the donut on as it would have been in stock form