please delete

[tekung89]

ozhonda peepz know their shietz =) thanks for helping guys

[sid]

borrow a set of ignition leads off a mate and replace it with yours. See if that does anything =\

[Sexc86]

99% sure you burnt out your ignition coil mate.... or sent it on its way. Go buy another one. like $60 from repco. i reccon thats the go.

Same thing happened to me after i fuct my coil

[tekung89]

hey guys update ~ fuse 7.5A (starter signal) under the dash board inside the car is not blown BUT it does not have any power wat so ever ,i connected my clip to the car chassi (negative) and touched it and the light doesnt turn on. so i connected the clip to power and touch both sides of that fuse and still it doesnt light up.

[tekung89]

hey lyle im not too sure if its the coil because the coil still appear to be silver in colour , if it burnt wouldnt it be another colour

[aaronng]

Ignition coil. Maybe people have experienced burnt ignition coils after doing a compression test with the coil still having power. Should have taken out the fuse before doing the compression test.

[tekung89]

but if its my ignition coil that is burnt, wouldnt it be in a burnt colour like brown or somthing? coz right now its still silver + i changed my dizzy to another one and still no spark.

jus wondering if fuse 7.5A (starter signal) is suppose to have power going to it. coz i test it with the light thing, and there is no power, but the fuse isnt blown.

[dsp26]

^^not neccesarily...

it is an expensive thing to go out and replace though... i'd suggest borrowing or gowing to a wrecker and trying both the coil and icm

[bennjamin]

yup agree with ignition coil.

It might work here and there , but due to the increased heat + load during a compression test , it practically melted. Take your dizzy odd , replace the coil and all should be good.

In future , you should disconnect the DISTRIBUTOR too during a compression test. Yes , disconect the side plugs to make sure !

[tekung89]

so this is wat i have to change?

http://importnut.net/forsale/b-coil.JPG

[tekung89]

we checked the ignition coil today with a electronic thing to see if there is power going to it. apparently there is but thats wat dad said =( because we put in another dizzy again that has previously been working and still no spark so i dunt think its the ignition coil guys.

last thing i can think of is quad-triple check my loom soldering. it might have came loose. if i stil dnt have any sparks im definately going to repco to buy myself a brand new ignition coil.