Can you power 2 subs off a monoblock amp?

[johnprocter]

Hey guys i was just wondering if i wanted to power 2 subs off this amp http://www.ryda.com.au/Kenwood-KAC-9103D-Car-Amplifier-p/kac9103d.htm
is it possible? do i have to find particular subs cause i have no idea what this ohm stuff means etc.. could i run these two subs from it? or would some more powerful subs be better? http://www.ryda.com.au/Clarion-DP12XB-2-x-12-Subwoofers-in-Box-p/dp12xb.htm

thanks

[VTi_b0i]

lol yes
ive got a 1000wat monoblock amp runnning 2x12 clarions in my runaround but i cant rememberr how i did it... if u need me to i can go out and look?

[EKVTIR-T]

http://akamaipix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/2SVC_4-ohm_mono.jpg

http://www.crutchfield.com/learningcenter/car/subwoofers_wiring.html

[VTi_b0i]

mines not like that rofl

[johnprocter]

enwood KAC-9103D
General Features
Aluminium Die Cast Heat Sink
MOS-FET Switching Power Supply
Detachable Aluminium Dress Plate & Top Panel Control
Single-side Exposure of Terminals for Multi-InstallationBuilt-in Variable Low-pass Filter 50-200Hz (24dB/oct)
Built-in Infrasonic Filter 15/25Hz (18dB/oct)
Bass Boost
1 Ohm Load Capacity
Gold Plated Input/ Output Terminals
Line Output Terminals (RCA) for Extension
Cooling Fan & Blue Illumination

Max Power Output
1800W

Rated Power Output (14.4V)
500W x 1 at 4ohms (20-200Hz 0.5%THD)
900W x 1 at 2ohms (1kHz 1.1%THD)
Over 900W at 1ohms
CEA-2006 Compliant
500W x 1 at 4ohms (1.0%THD+N)

these are the specs of my amp what two subs would work well with this? cause i want to run them both off the amp not buy another amp

[EKVTIR-T]

These guy's recommend single voice coil 4 ohm sub's for a single mono amp.

http://www.crutchfieldadvisor.com/S-a0DJ2dSBccL/reviews/20040427/subs_amps_guide.html?page=4

[destrukshn]

the pic explains it all, that's how you would run 2 single voice coil subs to a monoblock.

[RtN]

Sorry to Hi Jack.. what's voice coil? LOL Is it a better type of sub etc or what? And theres single and double voice coils?

[johnprocter]

gonna hook 2 alpine type R's from the amp i'll let you all know how it goes in a couple weeks :)

[aka_NSX]

base on RYDA website picture, you dont need to worry if you only running 2 subs with SVC 4ohms or 2 ohms but not 1ohm, just hook up both subs into the Amp since they are 4 speaker terminal already on the Amp and the Amp will bridge it internally, you dont need to follow the previous diagram

unless if your subs is DVC then is gonna be more complicated