Eg Question

[SuiJin]

I've got an Eg Hatch - ausdm
I've pulled apart anther Eg Hatch - jdm
Now looks like its not a straight fit for back interior of jdm to go into aus.

Im planning to do a little project with the interior, and was wonder what exactly would do perfect fits with ausdm eg hatch?

Question from boot, rear seats, plastics, front seats.
What kind of modification if any. [Ie Small Modification]

Does anyone wanna help lol.
Im in Melb. Footscray area.

[90LAN]

u need the jdm bracket for the seats to be bolted or weld in the back
for the jdm seats to fit
it is a rear seat support beam that goes from strut tower to strut tower
once u have done that everything will fit in

[SuiJin]

anything is i hate welding, also means needs cutting of ausdm model too.
i've got a full jdm model just bent chassis don't ask lol.

[SuiJin]

what about putting itr seats in.
and interior plastics?

[G-Stick]

if u want to put itr front or rear seats it, its a straight fit. but theres going to be a little gap on the sides of the rear seat

[teh_mechanic]

if u want to put itr front or rear seats it, its a straight fit. but theres going to be a little gap on the sides of the rear seat

the gap is pretty huge beside the bottom of the seat and the trim.looks pretty dodgy in my opinion

[G-Stick]

nah its fine. just put some material between it ;) not like ur going to be sitting in the rear anyways.

[SuiJin]

any recommendation for a straight fit nice set of back seatts lol

[90LAN]

u need ek9 ctr lower rear seats and itr dc2r upper rear seat to make it look flush