Integra Type R wheels fitment + clearance

[MickeyMickey]

I have seen this set of Enkei rims and I am wandering if they will fit my DC2 Integra Type R?

The size is:

Front: 16 x 7 offset +32mm 5 x 114.3
Rear: 16 x 8 offset +32mm 5 x 114.3

Also, if i am getting Spoon twin block calipers will these clear?

Any help?

[DLO01]

Depending on tyre size choice:
Fronts will probably be ok.... Maybe, with that offset.
Rears will be sticking out a bit. ie rubbing guards. Especially on a lowered DC2R. Your wheel size (width & offset) is too much for stock gaurds

Max I would go is 16x7 +40 205/45 tyre front and rear. Even then on the rear it getting extreemly close to the lip. Sure you can go a wider wheel, but the offset needs to be accounted for.

Regarding Spoon Calipers, your really need to do a test fit. Unless somone has used exactly the same setup as you eventually plan.

[Bludger]

I have seen this set of Enkei rims and I am wandering if they will fit my DC2 Integra Type R?

The size is:

Front: 16 x 7 offset +32mm 5 x 114.3
Rear: 16 x 8 offset +32mm 5 x 114.3

Also, if i am getting Spoon twin block calipers will these clear?

Any help?i'm sure the fronts will be ok, both with fitment and the spoon, but the rear may be too wide?

[MickeyMickey]

Thanks very much for the reply~!

[DLO01]

I have 16x7 +50 wheels with 205/45 tyres on now. I can adjust camber to whatever setting and no rubbing. 16x7 +40 I remember it rubbing a little on the rear when I had the camber standing up a bit. :thumbsup:

[MickeyMickey]

I see,

Im also on the lookout for the stock enkei 16inch rims, any idea where is best to look...

[Bludger]

they are rare to say the least

[VTECMACHINE]

I would use the 15 x 8's on the front... and 15x7 on the rear...

[T-onedc2]

I see,

Im also on the lookout for the stock enkei 16inch rims, any idea where is best to look...
Only JDM 98 spec has 16x7, extremely rare, all other Type R's have 15x6. The traders section occasionally have some.

[VTECACCORD]

which model are you after ?

rpf1 in +35 offsett and it has plenty of room to clear spoon calipers