cai install : pcv

[jim57a]

just bought cai for ek4

everything is done except for connection to PCV.

can somebody tell/show me please?

[DLO01]

What do you need to know?

What make is your new CAI?

If you have installed a new CAI you need to plumb in the rocker cover breather to the new intake arm, the same way the stock setup was previously. There should be a hole ready to accept this. Everything else in the PCV system will remain untouched.

Theres been a lot of talk about the PCV system. Please search and you'll find a lot of info. :thumbsup:

[jim57a]

thanks for the quick response.

i've got the injen cai from jdmyard.

the stock setup didn't have that hose connected so i couldn't just follow it.

tried searching "pcv" but nothing comes up.

[hisoka]

take a picture of ure engine bay..there shouldve been a little hose into ure stock intake piping. and to the rocker cover head.

[DLO01]

thanks for the quick response.

i've got the injen cai from jdmyard.

the stock setup didn't have that hose connected so i couldn't just follow it.

tried searching "pcv" but nothing comes up.

The Injen intakes have the small hole in the piping near the Throttle Body end. You need to run a pipe from the rocker cover breather (next to oil filler cap) to this small hole in the Injen pipe.