Parker Lights DC2/4

[tran06]

Hey,

I need help in changing parker lights for my DC4. I'm not too sure how the bulb fits inside.

http://i237.photobucket.com/albums/ff112/ttran06/DSC00261.jpg

[DC4Integra98]

Very easy;
Screw driver -unbolt
Twist and pull out the bulb assembly, put your T10's in, twist and bolt everything back on.

DONE!

Note: once you've actually unbolted it and taken a look at it yourself, it only takes common sense to figure the rest out.

[tran06]

what i did is that i pulled the bulb out..

but then it would go back into the hole?

i think i did it wrong?

http://i237.photobucket.com/albums/ff112/ttran06/IMG125.jpg
these are the bulbs


sorry for the quality, shit camera pictures

but when i tried to put the bulbs in.. it was loose and didnt fit in properly.

[DC4Integra98]

From memory you should be able to just push/slot it in place. Are you sure you purchased the correct parker lights i.e. T10

I'm guessing your old bulbs are blown as they are blacked out.

[dudeling7]

yeh they should just slot in the gap that you pulled it out of. the you just pop the socket in and twist till it locks again and put it back together. check if you got the right bulb.

[mars_panas]

If you still not sure how to install properly... try your Manual book should have it there... :p

I just recently installed parkers on my Jazz using my Manual book and it is helpful :thumbsup:

[VTECMACHINE]

Just play around man... it's not hard, and you can't really break anything down there.