Help!! on turbo timer...

[040501912]

Hi guys, i need help on my turbo timer,

I had Greddy turbo timer before, i install my self and it work :D but then it was sold, so i was left with out turbo timer for few months.. as car was being worked on.

I just bought Pivot baby timer, and i tried to hooked it on my car.
I used Volt meter to find out the cables.. because i forgot which cable i connect to last time,

Live constant wire 12V
1st switch - 12V
ACC - 12V
Ground and Hand brake cable.
I read through the manual.
http://pivotjp.com/download/img/pdf-e/SBT-e.pdf

Did everything accordingly (i guess :p) then i start the car up! all working in order until the key off.. then engine shut it self and left only with the fan working.

I tried to check all the wiring again, and all was "OK" but it keep doing the same thing! when shutting down car.. the engine is off!! and its not running when the turbo timer is counting down. :confused: i never had this trouble with the Greddy.. :(

any help would be appreciated, thanks

Chris

[Eire]

Generally all hondas ignition wiring is the same from what i've seen.

12v - thick white cable top left of fuse box in a brown plug with a seperate black and white cable in it (black and hwite is starter)

ACC - Yellow wire bottom right of fusebox in a brown plug

IGNITION - (which i suspect your missing or wired incorrectly) black/yellow wire in the same brown plug that the yellow wire is in.

[Eire]

Just to double up there by looking at your timer diagram

Red to the white cable
Yellow to the yellow and black
Blue to the Yellow
Black to earth
Brown to handbrake (i think the wire is green or red)

[040501912]

thx!! will check tomorrow