is the zc clutch same as a d16a8 or a d16z

[mickizzle]

hey guys just woundering is the zc clutch same as a d16a8 or a d16z????

[teh_mechanic]

what hes saying is:
we need to order him a new clutch for his zc crx engine thats in his eg.
Bursons and Repco etc, only have clutch part numbers for australian engines,but the zc is a jdm engine........

so are there any clutches that are the same as the zc, so we can order that one? or do we need to try and source a clutch for the jdm zc,this will be harder

[blk_shadow]

I believe the cluth from 89-91 CRX Si or Concerto will fit to ZC, which is D16a8/9

[qikteg]

d16a8 and zc are essentially the same thing. i imagine clutches would be interchangible between the two..

[defect]

i got a d16a8, quiet sure its the same as zc. i took my gearbox to exedy so they could match it up. bad thing is, i cant even remember which was for mine.

there is 2 different types of clutches for d16s, one uses 20 teeth, other has 21 teeth, but I think zc/d16a8 is the same thing.

[teh_mechanic]

problem solved guys.i put the clutch from my old twin carb engine i had lying around into his zc gearbox.runs fine.......for future reference - i was going to put my old twin carb gearbox on his car too,but its different to the zc gearbox but only very slightly - the zc runs larger diameter drive shafts (the driveshafts are a different design,they use a centre bearing whereas the twin carb doesnt,so i couldnt just put my old driveshafts into his car with my old box)

all over,car is bak out on the road :thumbsup: