View Full Version : clogged water spray nozzle
incoming
10-06-2008, 08:33 PM
how do i clean it out..?
tried air compressor, turps in coke bottle and shook it...
still clogged!!
any suggestions?
bennjamin
10-06-2008, 08:34 PM
how about you grab a pin or needle...and poke it in there. Should un clog it.
Zdster
10-06-2008, 08:35 PM
Get a small sewing needle and just push it through. Should clean it out fine.
dsp26
10-06-2008, 08:35 PM
have you checked that the mini pump is actually working by disconnecting the water lines from the nozzle?
using a pin usually does the trick cleaning those things...
bennjamin
10-06-2008, 08:36 PM
lol read before you hit that POST button
incoming
10-06-2008, 08:36 PM
oh yeah tried a pin
and yes water pump is working.. im not that much of a noob haha
Zdster
10-06-2008, 08:36 PM
lol read before you hit that POST button
I hit it at the same time as you did (even though it says a minute difference) :) :p
bennjamin
10-06-2008, 08:39 PM
god dam. lol
oi incoming....try this.
Open your bonnet and then spray the wiper motor. Does it spray ? Chances are the rubber piping is kinking up somewhere.
incoming
10-06-2008, 08:40 PM
haha ben yes i done that
thats how i know its the nozzles
i got one spraying but its piss weak
bennjamin
10-06-2008, 08:42 PM
tried swapping em side to side ?
dsp26
10-06-2008, 08:44 PM
just get some from pick n payless or those 3 nozzle ones from ebay or those wide spray ones from autobarn :p
incoming
10-06-2008, 08:44 PM
yep that too...
should prolly just get new ones hey
lukecivic
10-06-2008, 09:16 PM
maybe the pump isnt working at full power?
incoming
10-06-2008, 09:20 PM
how can i test that?
wouldnt BOTH noozles be spraying weak?
only 1 is spraying weak
fcuk i should just get to the wrecking yard
bennjamin
10-06-2008, 09:22 PM
disconnect the nozzles - put your finger/s over the pipes to both and get someone to spray the wipers - it should spray enough to get around your finger (like a hose)
Just go get some nozzles from the markets for like $5
use a pin to push tgrough where the water comes out
incoming
10-06-2008, 09:26 PM
man then $5 ones are chrome and look gay haha
EGJOE
10-06-2008, 09:29 PM
probly cloged with polish wax etc, try carby cleaner or soak in wax and grease cleaner or similar, then blow out with compressed air.
Wouldn't reccomend using pin as you might enlarge the hole changing spray pattern.
Good luck bud, and yeh theres always the wreckers
Zdster
10-06-2008, 11:00 PM
probly cloged with polish wax etc, try carby cleaner or soak in wax and grease cleaner or similar, then blow out with compressed air.
Wouldn't reccomend using pin as you might enlarge the hole changing spray pattern.
Good luck bud, and yeh theres always the wreckers
use a pin to push tgrough where the water comes out
These guys really dont read :o:zip:
EGJOE
11-06-2008, 05:42 AM
These guys really dont read :o:zip:
I luv haters so many on this forum, im in heaven:p:p:p
so_rnb
05-08-2008, 02:19 PM
I have this problem on the rear jet of my DC5. There is no buildup in the nozzle, as I have tried to use a pin etc... My next guess is to try and take it off and see. Anyonw know how to do that? Just now I tried to twist it off.. but it just keeps rotating, I tried pulling it up and pushing it forward/back/left right. I don't really want to break anything.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.