View Full Version : Installation of grill for EK1
Rambo2
12-06-2008, 12:59 PM
Hi guys,
I recently bought a grill for my EK and have been trying to figure out how to install it. I have heard that you need to remove the front bumper to take the existing grill off first. All help is greatly appreciated.
Cheers
ton3z
12-06-2008, 01:12 PM
hey man
yep thats right you need to remove the whole bumper because the stock grille is actually screwed to the bumper from underneath so those 4 plastic screws you see when you pop your hood aint going to remove the whole grille, although they do help.
ek9 did a post about how to remove resonator and he had some pics up as to how to remove the bumper and where the screws are.. here are the pics again for you...
9514
9515
9516
Raztaz
13-06-2008, 02:51 PM
search is your friend
http://www.ozhonda.com/forum/showthread.php?t=65486&highlight=grill
MikeyG
14-06-2008, 03:32 PM
ton3z said it look @ the pics and away u go :D
beeza
14-06-2008, 03:38 PM
I'm pretty sure I just ripped mine off...my aftermarket one didn't need to use those lower 4 screws anyways.
markoJEK1
14-06-2008, 03:58 PM
thats probably true, but thats why you dont see the aftermarket ones sitting flush with the bar, they always stick out
lukecivic
14-06-2008, 11:55 PM
you can actually remove the grill without removing the front bumper
reach under the bumper or through the lower black grill in the front bumper and reach up and you can feel the screws holding the grill
the rest if the screws and clips can be removed from above
it only takes about 10 minutes
beeza
15-06-2008, 10:16 AM
Yeah I needed my mate to help me fit my grille.I had to get my hand up underneath while he pushed on it but now it has shaped to it and it just slots strait in :)
ton3z
15-06-2008, 12:43 PM
yep the aftermarket grille i got for my car
doest sit fully flush as the orginal grille, cause they dont use the 4 screws underneath,
but my one did have 4 plastic things at the bottom that you can clip onto oringal bumper so that does hold the bottom in quite well and then screw in the 4 plastic screws and it shold fit like a gem.
hint: put the clips in from the bottom up and then whack the scews in, so the clips dont move.
hope all goes well
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.